Surface Piercing: A Piercee’s Guide

Piercing is really innovative these days and devastatingl

y fashionable. Naturally, it is done to allow the people to wear jewelry but there are many options even with the perforations. Surface piercing is popular amongst those who don’t want the piercing to go into their skin too deep. As is obvious by the name, it is done on skin’s surface – two perforations on the skin plane that penetrate into the skin a bare minimum. It should not be an impetuous decision though. Getting full information about the procedure and aftercare is always advised – it makes you more certain about your decision and help recognizes potential risks.

Surface Piercing Procedure

The very first thing to take into consideration is the studio you will be going to get your body pierced. Rather than going for a small and cheap studio, go to a professional studio which might seem a little expensive but in the long run, will prove a prudent choice. It is always better to get acquainted with the studio and the piercer personally and check out everything well in advance. Ask all the questions you need answers for without any reservations – this will help you and your piercer both. If he is kind enough to reassure you, go for it.




You’d need to decide where you want the piercing. Commonly, back of the neck, on the face and ear, chest, hip and belly button are favorable locations. The point is to get it somewhere where the contact is minimal with rough areas. How painful the piercing is depends on the location – finger, hip and wrist doesn’t hurt as much as face, collar bone and chest piercing. With surface piercing, there is minimal blood loss; a professional can very well take care of what does ooze out.

When starting the procedure, he will first clean the area you want pierced and disinfect his needle. It is very important to make sure his equipments are clean and sterilized; if he isn’t doing this, you’re probably going to get some infection later. Some clamp the skin when perorating to make the insertion smooth while some avoid it to position it correctly. In case he doesn’t clamp your skin, it will definitely hurt. He will also educate you about the jewelries you can use – mostly people use stapler pin kind of jewels. But that will happen only after a cleaning session and it will be followed by more cleaning. The pain of the piercing can take anything from 4 weeks to 8 weeks to fade away and it takes the piercing a minimum of 6 months to heal completely.

Surface Piercing Problems And Aftercare

There is no doubt that you need to be extra careful of the piercing. It should be protected from injuries or any unnecessary roughness. Playing with the jewelry is a strict no-no; it could lead to rejection or migration. There are times when the body rejects the intrusion and then pushes the jewelry out which causes tremendous pain. Migration, on the other hand, is when the jewelry shifts its place along with the piercing usually due to a heavy jewelry. For both the cases, it is recommended to use light jewelries and bigger anchors to give it space to heal.

Infection is another probable risk of surface piercing. If you let dirt settle on your pierced area, it will react for sure, swell or give rise to redness. Most of the times, it could be avoided by washing it with salt water two times everyday. Keeping it clean is the only way to avoid any infection.

Be the first to comment

Leave a Reply

Your email address will not be published.